Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
LASER MEASURING
TURN ON THE DEVICE
Press the MEAS button (2) to activate the device. Both the LCD screen and the
(1)
beam will turn on.
DEVICE SETTINGS
Short press the UNIT (1) button to select your measure plan : distance, surface
(2)
or volume.
Long press the UNIT (1) button (about 3 seconds) to switch the metric/inch.
(3)
Press MEAS (2) and UNIT (1) buttons simultaneously to change the baseline :
(4)
front or back.
TAKE A MEASURE
When the beam is activated, press the MEAS (2) button to trigger the distance
(5)
measurement. The laser point blink while measuring and turn off. The value is
immediately displayed on LCD screen.
(6)
Start a new measurement by pressing the MEAS (2) button again to re-activate
the laser beam, then repeat the above step (5).
TURN OFF THE DEVICE
Long press the MEAS (2) button (about 5 seconds) to power off the device.
(7)
Note :
The laser beam and the device turn off automatically after 30 seconds (beam) and
3 minutes (device) respectively to save the battery.
Publicité
Table des Matières
