Bypass Door - Napoleon HIGH COUNTRY 3000H Manuel D'installation Et D'opération

8.2

bypass door

The bypass door is an internal mechanism that allows the exhaust products to travel through an unobtrusive path
to the fl ue prior to engaging the catalyst.
The bypass door is operated by pulling the bypass rod located on the right side of the appliance out and down
until it catches and remains open. To shut the bypass door, pull the rod out and up allowing the rod to slowly
retract into the appliance. Be sure not to allow the bypass door to slam shut.
The bypass pull handle tool must be used with your appliance for adjusting the bypass rod. This tool will prevent
injury as the bypass rod becomes extremely hot as the appliance heats up. When you receive your appliance,
the bypass rod tool will come unassembled. It can be easily assembled by screwing the spiralled handle onto the
body of the tool.
1
Ensure bypass door is open during startup and re-
fueling. See above for bypass door rod location.
3
Press bypass rod downwards then inwards to lock into
Engage tool into the groove of the bypass rod
handle.
place.
2
Pull bypass rod outwards.
When hot, use tool provided.
4
Open fi rebox doors and load fuel.
operation
EN
35
W415-1761 / B / 12.21.18