Live Screen; Image Adjustment - RIDGID micro CA-350 Mode D'emploi

micro CA-350 Inspection Camera
Figure 11 – Splash Screen
(Note: Version will change with each
firmware update.)

Live Screen

The live screen is where you will do most of
your work. A live image of what the camera
sees is displayed on the screen. You can zoom,
adjust LED brightness and take images or
video from this screen.
The screen has a status bar at the top showing
the tool mode, zoom, SD™ card icon if in-
serted, available memory and speaker/mic
ON/OFF. The bottom bar shows information
about date and time if time stamp is ON.
Figure 12 – Live Screen
When the Inspection Camera is turned ON, the
default mode is for capturing still images.
Pressing the menu button at any time will ac-
cess the menu. The menu will overlay on the
LIVE Screen. Use the right and left arrow
buttons to switch to the MODE category. Use
the up and down arrows
tween menu items and press select
sired.
10
Figure 13 – Screen Shot of Mode Selection
3. If the other inspection camera settings
4. Prepare the camera for inspection. The
Status
Bar
Information
Bar

Image Adjustment

Adjust LED Brightness : Pressing the right
and left arrow button
live screen) will increase or decrease the
LED brightness. A brightness indicator bar
will be displayed on the screen as you adjust
brightness.
to navigate be-
as de-
(Time Stamp, Language, Date/Time, TV
Out, Update Firmware, Speaker/Micro -
phone, Auto Power OFF, Factory Reset)
need to be adjusted, see Menu Section.
camera cable may need to be pre-formed
or bent to properly inspect the area. Do not
try to form bends less than 5" (13cm) ra-
dius. This can damage cable. If inspecting
a dark space, turn the LEDs on before
inserting the camera or cable.
Do not use excessive force to insert or
withdraw the cable. This may result in
damage to the inspection camera or in-
spection area. Do not use the cable or im-
ager head to modify surroundings, clear
pathways or clogged areas, or as any-
thing other than an inspection device.
This may result in damage to the Inspec -
tion camera or inspection area.
on the button pad (In