Invacare SOLO2 TPO100 Manuel D'utilisation page 27

SECTION 6—OPERATING INSTRUCTIONS
The Standby screen provides both a battery gauge and a percentage of
remaining charge. It can also display the Fans Operating, External Power
On and Battery Charging icons when applicable.
Normal Operating Screen
When operating normally, the Mode & Flow display informs the user of the
current operating mode and the setting for that mode.
The display shows the current / last mode of operation selected. The mode
of operation can be either Continuous Flow or Pulse Dose. It will also show
the current/last output flow level selected.
This screen will alternate with the Standby screen every 20 seconds. In this
fashion the user will be able to see all the important information at a glance.
FIGURE 6.6 Normal Operating Screen
Mode & Flow Adjustment Screen
This screen allows the user to change the current mode of operation and
output flow. To access this screen, when the transportable oxygen
concentrator is operating and either the Normal Operating screen or the
Standby screens are shown, press and hold the Mode/Return/Highlight
button, Up/Increase, or Down/Decrease button for approximately 2 seconds
(screen should change to Mode & Flow Adjust).
Saving Mode Changes
Once the Mode & Flow screen is displayed, press and hold the
Mode/Return/Highlight button for one second to change the mode. Wait for
the screen to flash three times for the changes to take effect. See the section
on Control/Adjustment buttons.
Saving Flow Changes
Once the Mode & Flow screen is displayed, press and hold the Up/Increase,
or Down/Decrease button until desired setting is achieved. Wait for the
screen to flash three times for the changes to take effect. See the section on
Control/Adjustment buttons.
LCD Adjustment Screen
This screen is used to adjust the brightness and contrast of the LCD. When
available, this screen can also be used to change screen language.
Part No 1163190 27 Invacare SOLO ™
2