Starting Operation - FLUX F 520 S-50/45 Mode D'emploi

Starting Operation

Available drive motors:
! Three-phase motors up to max. 3 kW
! Compressed air motors FPM 4 Ex, FPM 6 Ex, FPM 8 Ex
! Installation of three-phase motors should only be carried out
by suitably qualified personnel.
! Only use three-phase motors with a starter including
an overload cut-out.
! Make sure that the supply voltage corresponds to the
voltage indicated on the name plate. When using air
motors, please do not exceed the maximum operating
pressure and use a filter-regulator-lubricator unit.
! Check direction of rotation of the motor.
In case of portable use, check direction of rotation before
starting each operation.
(Direction of rotation according to the arrow on the bearing flange).
! Clean bearing and motor flange.
! Fit the motor onto the bearing flange and tighten the screws.
Centering at the
bearing flange
motor
direction of rotation
arrow
bearing flange
4 screws with
hexagonal
recessed hole
11