Briggs & Stratton 21114 Série Manuel D'installation Et D'opération page 23

To open internal guard:
1. Make sure the roof is in the open position.
2. Remove the two bolts (G) that secure the internal
guard to the unit.
3. Lift up on panel and secure with the tab on roof
latch.
To close internal guard:
1. Move the tab on roof latch to release the guard, then
lower the guard into place.
2. Install the two bolts.
To remove front panel:
1. Remove the two bolts (H) that secure the panel to the
unit.
2. Lift panel up and away from the enclosure.
To install front panel:
1. Hold panel a few inches above the sill and fit it
into the enclosure opening. Slide the panel down
until the bottom edge contacts the sill.
2. Install the two bolts.
G
H
To remove rear panel:
1. Insert key into lock (J) of rear panel. Turn key one
quarter turn counterclockwise.
2. Tilt panel open until it clears the roof hinges.
3. Lift panel up and away from the enclosure.
To install rear panel:
1. Fit the bottom edge of the panel into the sill.
2. Tilt the panel forward until closed. Turn key clockwise
to lock the panel in place.
J
23