Changing Engine Oil And Oil Filter - Briggs & Stratton 21114 Série Manuel D'installation Et D'opération

Changing Engine Oil and Oil Filter

KEEP OIL OUT OF REACH OF CHILDREN.
DON'T POLLUTE. CONSERVE RESOURCES.
RETURN USED OIL TO COLLECTION
CENTERS.
Change the oil while the engine is still warm from running.
1. Stop the generator.
2. Disconnect the negative ( - ) cable at the battery.
3. Place oil drain hose into an approved container.
4. Remove brass fitting from end of oil drain hose.
5. When oil has drained, replace brass fitting on hose.
6. Place an approved container beneath oil filter area.
7. Remove oil filter and dispose of properly.
8. Before installing a new oil filter, lightly lubricate the oil
filter gasket with fresh, clean oil.
9. Install the oil filter by hand until the gasket contacts the
oil filter adapter, then tighten the oil filter ½ to ¾ turn.
10. Add the required amount of oil to bring the level up to,
but not over, the "FULL" mark on the dipstick. Install the
oil filler cap and wipe up any spilled oil.
11. Connect the negative ( - ) cable at the battery.
12. Set the generator mode to AUTO.
26
Engine Drive Belts
The engine installed in this equipment uses drive belt(s) that
drive the water pump and alternator. The drive belt(s) are an
integral part of the cooling and charging system and should
be inspected according to the maintenance schedule. When
inspecting the belts, check for:
• Cracks
• Chunks missing from the belt
• Splits
• Material hanging loose from the belt
• Glazing, hardening
If any of these conditions exist, the belts should be replaced.
Engine Cooling System
WARNING
Hot pressurized coolant could cause serious
injury.
• DO NOT open radiator cap when hot.
• Before servicing, allow coolant to cool.
With the engine cold, check the coolant level in the coolant
recovery bottle (see Component Locations). Use a 50/50
mixture of automotive ethylene glycol and distilled water.
NOTICE
Do not use alcohol- or methanol-based anti-freeze
or plain water in the cooling system at any time.
The cooling system must be maintained according to the
maintenance chart. Inspection should include:
• The regular removal of dust, dirt, and debris from the
radiator core and fan shroud.
• Inspection of coolant hoses and components for
leaks, especially at the radiator hose connections.
Tighten hose clamps if necessary.
• Check radiator hoses for swelling, separation,
hardening, cracks, or any type of deterioration.
• Inspect the radiator cap to make sure proper sealing.
BRIGGSandSTRATTON.COM