Gree GMV-680WM/E-X Manuel D'utilisateur page 5

Never fail to comply with the
nitrigen charge
requirements.Charge nitrogen
when welding pipes.
Please firstly connect the wired
controller before energization,
otherwise wired controller can
not be used.
Do not insert fingers or objects
into air outlet/inlet grille.
Never start up or shut off the air
conditioner by means of directly
plug or unplug the power cord.
Do not allow children operate
this unit.
Turn off the unit or cut off the
power supply before cleaning
the unit, otherwise electric shock
or injury may happen.
Do not expose the unit to the
moist or corrosive
circumstances.
Volatile liquid, such as diluent or
gas will damage the unit
appearance.Only use soft cloth
with a little neutral detergent to
clean the outer casing of unit.
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
2
GMV DC Inverter VRF
Never short-circiut or cancel
the pressure switch to prevent
unit damage.
Before using the unit, please
check if the piping and wiring
are correct to avoid water
leakage, refrigerant leakage,
electric shock, or fire etc.
Open the door and window
and keep good ventilation in
the room to avoid oxygen
deficit when the gas/oil
supplied heating equipment is
used.
Turn off the unit after it runs at
least five minutes; otherwise it
will influence oil return of the
compressor.
Do not operate this unit with
wet hands.
Never spray or flush water
towards unit, otherwise
malfunction or electric shock
may happen.
Electrify the unit 8 hours
before operation. Please
switch on for 8 hours before
operation. Do not cut off the
power when 24 hours
short-time halting (to protect
the compressor).
Under cooling mode, please
don't set the room temperature
too low and keep the
temperature difference
between indoor and outdoor
unit within 5.