Co N N Ec Ti N G Th E D E V I C E To Th E P Ow E R S U Pply; Bat Te Ry Pr Otec Ti O N Le Ve L - Indel B FM7 BACK Instructions D'utilisation

CO N N EC TI N G TH E D E V I C E TO TH E P OW E R S U PPLY

BAT TE RY
The device is operated at 12/24 Volt DC.
Attention
The power supply cable must be as short as possible and not interrupted so as to avoid any
voltage loss or power loss. Do not use additional switches, plugs, and junction boxes.
Attention
When connecting the battery, make sure that polarity is respected and protect power supply
with a 15 A fuse.
Attention
Before charging the battery with a fast battery charger, disconnect the power supply cable of
the device and other points of use, if any. Overvoltage may damage the electronic system of
the device.
The device is protected by an additional fuse of 7.5 A on the power supply line. In case of fuse
blown, remove it and introduce a new one.
Always switch the device off and disconnect it from the power supply line before
controlling or replacing the fuses.
In case of lack of operation from the device, always check the fuse integrity.
The damaged fuse (blown) must be replaced by a fuse having the same technical characteristics.
CO M PR E S S O R S TATI O N
Functions and features.
The compressor station is an electronic device which has the function of piloting the motor of the
compressor and carrying out all the controls and electrical protection of the system.
Its main features are as follows:
Protection of the battery through automatic turning off of the compressor when the feeding
voltage reaches the minimum threshold.
The compressor will start up again automatically when the voltage goes back to normal values.
Note: these values have been measured at control unit input and/or on the DC socket.

BAT TE RY PR OTEC TI O N LE VE L

BAT TE RY
PROTEC T I ON
CUT-OUT
CUT-IN
12V
10.4 V (± 0.3 V)
11.7 V (± 0.3 V)
33
24V
21.3 V (± 0.3 V)
22.6 V (± 0.3 V)