M AINTE NAN CE
Attention
Cut power off before performing any operation on the device.
Attention
Regularly perform the maintenance operations described here below and have them done
only by qualified and authorized personnel.
C LE A N I N G
Respect the following cleaning operations for a correct maintenance of the device:
•
Regularly clean the inside and outside of the device using only warm water and a neutral
detergent. Aspirate any solid residual (dust, particles, etc.).
•
After washing, rinse with clear water and dry with a soft cloth.
•
Avoid penetration of the cleansing agent through the hollow spaces or the openings of
the device.
•
Do not use: specific products for glass and mirrors; liquid, powder or spray detergents;
solvents; alcohol; ammonia or abrasive products.
•
When the device is not used, dry the inside and leave the door partially open to ensure
ventilation.
•
After it has been used for a long time, make sure dust does not obstruct the ventilation grilles.
•
Keep the door seal free from mold and oil. Regularly make sure that no signs of aging are
present, so as to avoid poor sealing efficiency.
•
Clean the condenser at least once a year.
U S E FU L TI P S
If the device fails to operate or operation is irregular, before contacting one of our
After-Sales Service Centres, make sure that:
•
power supply is provided
•
voltage corresponds to the value indicated in the plate
•
connections and polarity are appropriate
•
the refrigerating unit is not placed close to a heat source
•
the fuse of the supply line is not interrupted.
Attention
Only skilled personnel, or personnel belonging to an After-Sales Service Centre approved by
the Manufacturer, must replace the power supply cable.
Attention
Using accessories and cables other than the supplied ones may cause an increase of the
electromagnetic emissions or an increase of the electromagnetic immunity of the device.
Indel B shall not be held responsible for the failure to comply with all the regulations indicated
in this manual.
37