Operation Modes; Parts Counting - KERN and SOHN KXS-TM Instructions D'utilisation Et D'installation

10 Operation Modes

10.1 Parts counting

Before the balance can count parts, it must know the average part weight (i.e.
reference). Proceed by putting on a certain number of the parts to be counted. The
balance determines the total weight and divides it by the number of parts, the so-
called reference quantity. Counting is then carried out on the basis of the calculated
average piece weight.
As a rule:
The higher the reference quantity the higher the counting exactness.
 In weighing mode
used to set the reference quantity.
 Use
to set the desired reference quantity (e.g. 100),
selectable 10, 20, 50, 100 or 200
 Place as many parts to be counted (e.g. 100 items) as required by the reference
number of parts.
Acknowledge with
current quantity (such as 100 items) will be displayed.
 Remove reference weight. The balance is from now in parts counting mode
counting all units on the weighing plate.
 Back to Weighing mode by
KXS_KXG-TM-BA_IA-e-1932
, press and hold until the message „P 10" appears that is
. The weighing scales calculate the reference weight. The
.
29