EUROM INDUSTRIAL HEATING LAMP Mode D'emploi page 17

Cleaning and Maintenance
Keep the heater clean. Deposits of dust and dirt in the appliance are a common
cause of overheating so these should be removed regularly. Switch off the heater,
remove the plug from the socket and allow the heater to cool down before cleaning or
carrying out maintenance work..

Wipe the outside of the heater regularly with a dry or slightly damp cloth. Do not
use aggressive soaps, sprays, cleaners or abrasives, waxes, polishes or
chemical solutions!

Use a vacuum cleaner or compressor to carefully remove any dust and dirt from
the grills. Be careful not to touch or damage any internal parts during cleaning!

The heater contains no other parts which need maintenance.

At the end of the season, store the cleaned heater in the original packaging if
possible. Store upright in a cool, dry and dust-free place.

Do not dispose of the heater with household waste when it becomes worn or
damaged beyond repair. Take it to your local authority's collection point for
electrical appliances where any reusable materials will be collected and
redistributed.
CE-statement
Euromac bv., Genemuiden-NL hereby declares that the EUROM workspace
heaters, type INDUSTRIAL HEATING LAMP complies with the LVD guideline
2006/95/EC and the EMC guideline 2004/108/EC and meets the following standards:
EN 60335-1:2012
EN 60335-2-30:2009
EN 62233 :2008
Genemuiden, 19-03-2013
W.J. Bakker, alg.dir.
EN 55014-:2006/+A1 :2009/+A2 :2011
EN 55014-1997/+A1 :2001/+A2 :2008
EN 61000-3-2006/+A1:2009/+A2:2009
EN 61000-3-3 :2008
17