Publicité
Les langues disponibles
Les langues disponibles
Technical data
Type
Supply voltage
Maximum capacity
Settings
Insulation class
Dimensions
Weight
General safety instructions
1. Before using the machine, carefully read this entire instruction manual.
2. Before using your new heater, check it, including cord and plug, for any visible
damage. Do not use a damaged heater, but send it back to your dealer for
replacement.
3. This heater is exclusively intended to heat workspaces such as workshops,
garages and storage spaces. Use the appliance for this purpose only.
4. This heater in not suitable for use in wet or damp spaces such as bathrooms and
laundry rooms. Do not place the heater in the vicinity of taps, bathtub, shower,
pool, fountains or other sources of moisture. Make sure it cannot fall into water
and prevent water from getting into the heater itself. If, at any time, the heater
does fall into water, unplug it immediately! Do not use a heater that has a damp
interior but have it repaired. Never immerse the heater, cord or plug in water and
never touch it with wet hands.
5. The supply voltage and utility frequency, specified on the machine, need to match
those of the socket that is used. The electrical installation needs to be protected
by a residual current device (max. 30 mAmp). Only connect the heater to an
earthed socket!
6. Fully extend the cord before plugging in the heater. Make sure it does not come
into contact with any part of the heater and prevent it from heating up any other
way. Do not run the cord underneath carpeting; do not cover it with mats, carpet
strips or similar and make sure it is not placed in any passageways. Make sure
the cord cannot be stepped on and that no furniture is placed on top of it. Do not
lead the cord around sharp corners and do not roll it up too tightly after use!
7. If possible, do not use an extension cord, as this poses the risk of overheating
and fire. If the use of an extension cord is unavoidable, then make sure it is an
undamaged, approved extension cord with a minimum diameter of 1.5 mm²,
suitable for a minimum permissible power of 1000 Watt. To prevent overheating,
always fully extend the cord!
8. Do not use the heater outdoors and do not use it in spaces smaller than 6 m². Pas
op! Caution! The heater does not have a thermostat. Do not allow people who
English
INDUSTRIAL HEATING LAMP
Volt/Hz
220-240 / 50
Watt
800
0 – 400 - 800
Watt
IP24
cm
27 x 23 x 33
kg
2
13
Publicité
