Manual Setup (First-Time Use) - Jennair W10918236C Guide D'utilisation Et D'entretien

GETTING STARTED

MANUAL SETUP (FIRST-TIME USE)

— ACCESS POINT METHOD
This procedure uses Micro Access Point
technology and is applicable if your router does
not support WPS.
1.
Before starting the Setup procedure, please
take note of the home wireless network
name (SSID), its password and the SAID of
appliance. These will be required during the
installation process.
2.
Turn on your router and make sure the
internet connection is working.
3.
On your appliance, activate the provisioning
process using the AP method. You
should see the Wi-Fi icon blinking on the
appliance HMI.
4.
Turn on your smart device (phone or tablet)
and access your list of available wireless
networks in the settings menu.
5.
The appliance has created a wireless
network (SSID). Select this network from
the list of available wireless networks. The
network name is made up of the prefix
from your appliance type (e.g. washer,
dryer, etc.) followed by the MAC address (ex.
REFRID_88_E7_12_B3_66_ C3). If you don't
see it, you may need to refresh the list of
networks or verify the Wi-Fi icon is on the
appliance display.
6.
Once you have selected the SSID, a
password will be required. Use the SAID as
a password (i.e., 444441ABCD).
NOTE: This password is case-sensitive.
7.
Connect to the network.
8.
Wait until your device is confirmed to be
connected to the appliance Wi-Fi network.
9.
Open a web browser. If nothing appears,
type "192.168.10.1" in the address bar (URL)
and press Enter. The browser displays a
Smart web page. It is the configuration
page of the Wi-Fi radio of your appliance.
16 | GETTING STARTED
10.
In the drop-down list of available networks,
select the name of your home wireless
network.
11.
If your home wireless network is hidden,
select "Other" and manually enter its name
(SSID) and security protocol.
WPA2
12.
Enter the password for your home wireless
network, if required, and submit.
Remember, this kind of password is case-
sensitive.
13.
Click the " " button to submit, and wait a
few seconds.
14.
The Wi-Fi icon on the appliance should stop
blinking and turn on permanently once
connected. Otherwise, disconnect and
reconnect the appliance to the main power
and repeat the procedure.
15.
The Setup process is complete.