Automatic Setup (Wps) - Jennair W10918236C Guide D'utilisation Et D'entretien

GETTING STARTED
AUTOMATIC SETUP—WI-FI
PROTECTED SETUP (WPS)
YOU WILL NEED:
A home wireless router capable of WPS (Wi-Fi
protected Setup). The router should be on and
have a live internet connection.
To use this feature you need:
A smartphone running Android 4.3 (or
higher) with a 1280x720 (or higher) screen
or a tablet or a smartphone running iOS 8
(or higher).
A wireless router 2.4 Ghz Wi-Fi b/g/n
connected to internet (verify with your
smart device that the signal of your home
wireless network is strong close to the
appliance).
The Smart Appliance Identification Number
(SAID) from your refrigerator. This is located
on a sticker on the inside of the water filter
door.
SAID: 0123456789
Contains FCC ID: A5UWICHIN01
MAC ID: 88:E7:12:XX:YY:ZZ Contains IC: 10248A-WICHIN01
NOTE: If your home wireless router is not
equipped with a WPS button, please check
the user manual of your router to confirm
if it is WPS capable. If not, alternate setup
instructions are at www.jennair.com/connect.
In Canada, use jennair.ca/connected.
14 | GETTING STARTED
1.
Set up router
INTERNET
WI-FI PROTECTED
SETUP (WPS)
HOME WIRELESS
Press the WPS button on the router. An
indicator light will begin blinking.
NOTE: The WPS function on your router is
active for 2 minutes. Complete the next step
within that timeframe, or you will need to
reinitiate WPS.
2.
Set up refrigeration appliance
(time-sensitive step)
router attempt to connect. If the
connection is successful, the Wi-Fi status
indicator will illuminate and remain lit.
IF YOUR APPLIANCE DOESN'T CONNECT:
ROUTER
If your appliance and router fail to connect after
2 minutes, the Wi-Fi status indicator will blink
rapidly for 5 seconds and then turn off. Check
any connection instructions for your specific
router, and refer to alternate instructions at
www.jennair.com/connect. In Canada, use
jennair.ca/connected.
NOTE: If this is your first smart appliance, you
will need to download the JennAir
create an online user account.
If you already have the app and a user account,
please skip ahead to Step 4, "Register your
refrigerator in your user account."
Press and hold CONNECT on
the control panel for
3 seconds.
The Wi-Fi status indicator ( )
on the appliance control
panel will blink slowly
while your appliance and
App and
®