Driving The Vehicle - Revell Control MAD MACHINE Mode D'emploi

1. geTTINg STArTeD:
Place the vehicle on the floor with its rear facing you. Connect the cables from the battery
and motor in the vehicle (Fig. 1). Also ensure before starting that the trim controls for speed
and steering (TH. TRIM and ST. TRIM) are at their middle positions.
Be sure to follow this order when switching on the vehicle: Set trim-control speed to
the centre position. Set the ON/OFF switch on the side of the remote control to "ON" (Fig. 2).
The two power LEDs on the remote control light up red and green when the battery is fully
charged (Fig. 3). Then set the ON/OFF switch on the vehicle to "ON" (Fig. 4). Two acoustic
signals indicate: the vehicle is ready for operation.
Please note: When the vehicle and remote control are switched off, the ON/OFF switch on
the side of the vehicle must be set to "OFF" first (see Fig. 4). Only then should you set the
ON/OFF switch on the remote control to "OFF" (Fig. 2). Otherwise you can accidentally give
a signal that causes the vehicle to start by itself, which can lead to significant damage.
Pull the antenna wire through the antenna holder and fasten the end of the wire with the
rubber cap (Fig. 5). Do not cut off the remainder of the antenna wire!
2. TrIMMINg SPeeD AND coNTroLLer:
Correct trimming is crucial for ensuring that the vehicle drives smoothly. It is easy to do, but does require a little patience and a light touch. Please follow these instructions carefully:
If the vehicle moves forwards
or backwards without anyone
touching the speed control...
If the vehicle moves forwards or backwards without anyone
touching the speed control, turn the speed trim control (TH.TRIM)
in the opposite direction until the vehicle stops by itself.
3. Truggy coNTroL:
Forward movement
To start the vehicle and move forward, carefully pull the speed
control. To go faster, carefully pull the speed control further.
To take left corners, turn the steering control to the left,
assuming the back of the vehicle is facing the driver.
Tip: The reverse switches for the
speed control (TH) and steering
control (ST) can be used to reverse
the function of the respective controls.
The settings should only be changed
while the vehicle and remote control
are switched off.
8

Driving the vehicle

Fig. 1
If the vehicle's wheels turn to the left or right without anyone turning the steering,
turn the steering trim control (ST. TRIM) in the opposite direction until the wheels
are straight and the vehicle moves in a straight line. It is best to trim the steering
while the vehicle is travelling slowly.
Braking and reversing
To brake, carefully push the speed control forward until the vehicle stops or
slows down. To reverse, push the speed control further.
To take right corners, turn the steering control to the right,
assuming the back of the vehicle is facing the driver.
Fig. 2
Fig. 4
If the wheels of the vehicle
turn to the left or right without
anyone turning the steering...
Fig. 3
Fig. 5