Charging The Drive Battery; Filling The Water Tank - Revell Control AMPHIBIOUS SCOUT Mode D'emploi

3 INSerTINg BaTTerIeS
3E Then unscrew the three fastening screws.
3F Now the water cannon structure can be removed.
3G The structure is provided with a rubber seal. Carefully remove the seal.
3H Then connect the plug of the drive battery to the socket in the model. Do not use
force when inserting and pay attention to the correct polarity.
3l When applying the seal, make sure that it is arranged straight and in the intended
position.
3J Now re-insert the structure with the lug facing forward and screw in the three
screws hand-tight.
4 STarT preparaTIoN
Before switching on for the first time, the transport lock must be removed (4A) and
the antenna must be screwed in clockwise (4B). To switch on, move the switch on the
rear side of the remote control to ON (4C), then set the switch on the upper side of
the model (4D) to ON. This switch has a waterproof seal, so it must be pressed down
firmly.
When switching off, always switch off the vehicle first (cf. 4D), then the remote control
(cf. 4C)! Otherwise, a drive command can accidentally be triggered, causing the vehicle
to drive away on its own, which can lead to considerable damage.
5 vehICle CoNTrol
Control of the vehicle is identical on land and in water. If the wheels are folded up, the
boat propellers on the rear side automatically activate.
5A
In order to start and drive forwards,
push the left and right control pads
on the remote control forwards at the
same time. In order to drive a left curve,
briefly release the left lever.
5C
In order to extend and retract the
wheels, press and hold the top left
shoulder button until the limit position
is reached.
14
5B
In order to drive backwards, press the
left and right control pads on the remote
control downwards. You can also drive
along a curve during reverse travel by
briefly releasing one throttle lever.
5D
The water cannon is activated with the
top right shoulder button on the remote
control.

6 ChargINg The drIve BaTTerY

Attention: Always follow the instructions when charging your battery. Before charging
and after each use, the battery and the motors must cool down for 15 to -30 minutes.
Failure to do so may result in the battery becoming damaged. The charging process
must be constantly monitored. Always ensure that the charging process takes place on
a fireproof surface in a fire­resistant environment.
6A To charge the drive battery, first insert the charger into a mains outlet.
6B Then connect the battery to the charger. The red LED on the upper side of the
charger illuminates during the charging process. The charging process takes
approximately 3 hours. The battery is fully charged once the red LED on the
charger goes out or the battery becomes warm.
6C Immediately discontinue the charging process if the battery is fully charged or if
it becomes warm or even hot. To do so, unplug the battery from the charger and
pull the charger out of the outlet. .
After a charge time of approximately 3 hours, the amphibious vehicle can be driven
for up to 20 minutes.

7 FIllINg The WaTer TaNk

7A A water tank is arranged behind the water cannon. Open the plug on the rear side by
turning it anticlockwise.
7B To fill the tank, hold the model down vertically and carefully fill with water.
The tank may only be filled with water; other liquids destroy the pump.
7C A hose is also included with the model. It is screwed in behind the water cannon
instead of the plug. Now the water cannon can be supplied directly with water
from the surrounding body during travel.
15