How To Navigate - Em 215Ic; Symbol Reference Em 215Ic - ESAB EMP 215ic Manuel D'instructions

6 CONTROL PANEL
6.2

How to navigate - EM 215ic

6.2.1

Symbol reference EM 215ic

Overtemperature
Spool Gun
Smart MIG
Wire diameter (sMIG mode
only)
Manual MIG
0463 407 001
1. Spool gun indication: Symbol illuminates
when spool gun is connected.
2. Over temperature indication: Symbol
illuminates when product is overheated.
3. Volt/Amp display: LED displays the Volts
and Amps values during welding. It holds
the last used parameter.
In sMIG "V" displays the wire diameter
while idle "A" displays the set wire feed
speed.
4. Voltage knob: Adjust the voltage value (in
sMIG not functional).
5. Knob for plate thickness or wire feed
speed: in sMIG mode (outer circle, in
yellow) plate thickness can be adjusted.
Wire feed speed can be adjusted when in
manual MIG/MAG or flux cored (inner
circle, in white).
6. Process selection knob: Enables
selection between sMIG mode (left, in
yellow) and manual MIG mode (right, in
white).
Volts (manual MIG mode only)
Amps
Wire feed speed
Thickness gauge (sMIG
mode only)
- 36 - © ESAB AB 2017