Testing The Pet Fencing System (Boundary Range); Adjusting The Stimulation Level - Num'axes Canifugue 2015 Guide D'utilisation

Testing the pet fencing system (boundary range)

•
Before releasing your dog into his play area, you need to physically evaluate the extent of the authorized zone. Make sure
your dog has enough space to move freely within the defined limits.
The wider the zones, the lower the escape risks. Therefore, you have to find a good compromise between zone width
and freedom space.
In order to test the installation, proceed as follows:
− Before doing so, make sure the receiver collar is turned Off (indicator light Off).
− Fix each wire of the neon test lamp under each contact point (unscrewing them lightly and retightening them so as to pinch
the test lamp wires).
− Turn On the transmitter and the receiver collar.
− Set the warning and stimulation zones on the levels that seem appropriate.
− Stand at the centre of the authorized area holding the collar by the strap at the same height and orientation as if on your
dog's neck. Then walk towards the edge of your property where the antenna wire is laid. At a certain distance from the
wire, the collar should emit beep sounds. Then, when you carry on, the neon test lamp should light indicating stimulations
are emitted. If you think the zones are insufficient or too important, go back to the transmitter to modify the settings. Check
the new settings on your property. Test the settings in a number of different areas of the installation to ensure that the
functioning is constant.
− When the zone setting is complete, walk all around the authorized area holding the collar by the strap at the same height
and orientation as if on your dog's neck in order to check that there is no loss of signal.
− Before disconnecting the neon test lamp, make sure the receiver collar is turned Off (indicator light Off).
WARNING: Do not test or adjust the system while the collar is on your dog.

Adjusting the stimulation level

•
8 stimulation levels (modes) are available on each receiver collar so you can adjust the product to your dog (size, sensitivity,
temperament).
In the factory, the collar is set on mode 4.
Always start with a low level of stimulation and define the level from which your dog reacts by increasing gradually.
27