How The Pet Fencing System Works; Installing The Pet Fencing System - Num'axes Canifugue 2015 Guide D'utilisation

Nylon strap
Indicator light:
On/Off indicator
+
battery level indicator
•

How the pet fencing system works

You can define your dog's play area by installing a wire, called antenna wire, around the authorized perimeter. This wire placed
on the ground, buried or raised on an existing fence carries a radio signal from the transmitter.
When your dog, wearing a receiver collar, approaches this wire, he is warned by beep sounds that he is too close to an area
where he is not allowed; then if he carries on, static stimulations will be emitted by the collar. Your dog will have to leave the
unauthorized area to stop the stimulations and beep sounds.
An unlimited number of receiver collars can be used with one transmitter: you can keep as many dogs as
you wish safely in the same area.
The CANIFUGUE pet fencing system has been designed to give you complete satisfaction with an antenna wire with a
maximum length of 400 meters (equivalent to one square hectare). If a longer antenna wire is used, the pet fencing system
will still work, but the warning and stimulation zones will be markedly reduced.
•

Installing the pet fencing system

• Transmitter
The transmitter must be installed indoors in a dry location: the transmitter can withstand changes in temperature but will be
damaged by water. Make sure the transmitter is correctly and surely fixed (for example screw it to a wall).
Install the transmitter in a garage or garden shed near an electrical outlet (220 V AC).
Contact points
(short or long)
22
Diagram 2 – Receiver collar
symbol:
area where the magnetic switch is
located.
This magnetic switch allows you to
turn On/Off the collar and to select the
stimulation level.