Testing The Pet Fencing System (Boundary Range); Adjusting The Stimulation Level - Num'axes Canifugue Small Guide D'utilisation

Testing the pet fencing system (boundary range)

•
Before releasing your pet into his play area, you need to physically evaluate the extent of the authorized zone. Make sure
your pet has enough space to move freely within the defined limits.
The wider the zones, the lower the escape risks. Therefore, you have to find a good compromise between zone width
and freedom space.
In order to test the installation, proceed as follows:
− Before doing so, make sure the receiver collar is turned Off (indicator light Off).
− Fix each wire of the neon test lamp under each contact point (unscrewing them lightly and retightening them so as to pinch
the test lamp wires).
− Turn On the transmitter and the receiver collar.
− Set the warning and stimulation zones on the widths that seem appropriate.
− Stand at the centre of the authorized area holding the collar by the strap at the same height and orientation as if on your
pet's neck. Then walk towards the edge of your property where the antenna wire is laid. At a certain distance from the wire,
the collar should emit beep sounds. Then, when you carry on, the neon test lamp should light indicating stimulations are
emitted. If you think the zones are insufficient or too important, go back to the transmitter to modify the settings. Check
the new settings on your property. Test the settings in a number of different areas of the installation to ensure that the
functioning is constant.
− When the zones setting is complete, walk all around the authorized area holding the collar by the strap at the same height
and orientation as if on your pet's neck in order to check that there is no loss of signal.
− Before disconnecting the neon test lamp, make sure the receiver collar is turned Off (indicator light Off).
WARNING: Do not test or adjust the system while the collar is on your pet
•

Adjusting the stimulation level

8 stimulation levels are available on each receiver collar so you can adjust the product to your pet (size, sensitivity, tempe-
rament).
In the factory, the collar is set on level 4.
Always start with a low level of stimulation then define the level from which your pet reacts by increasing gradually.
27