Num'axes Canifugue 2015 Guide D'utilisation page 24

• Layout of your installation
Before starting the installation of your pet fencing system, it may be useful to draw a layout of the installation.
Once the installation is completed, note the location of the wire connectors on the layout you drew for future reference. In
case of connection default, you will find them more easily.
Diagram 3 – Sample installation
AUTOMATIC SYSTEM
As soon as the animal wearing a collar
enters the protected area, he is warned by
Antenna wire
beep sounds.
2 m between
If he continues to move forward, towards
both wires
the antenna wire, the collar emits
Warning
stimulations.
By twisting the outward strand with the inward
area
The antenna wire is placed on the ground,
strand, wave emission is blocked and the
buried or raised on an existing fence.
animal can move freely within this zone.
For the system to function, the wire must
Stimulation
form a continuous loop.
area
Both wires (inward and outward) must be Transmitter
spaced 2 meters apart.
Twisted wire
• Activate/deactivate the transmitter
• Activate: connect the transmitter to the power supply by plugging the AC adapter into the power jack on the transmitter
and into a wall outlet. The green indicator light comes on, the transmitter is On.
• Deactivate: disconnect the AC adapter from the wall outlet. The green indicator light goes out, the transmitter is Off.
NOTE: do not connect the transmitter to the power supply before connecting the antenna wire to the antenna socket. The wire
break alarm would alert you to a connexion default (ref. § Safety features).
• Fitting the battery in the receiver collar
− Unscrew the 4 screws of the battery cover using a screwdriver.
− Insert the battery (3V Lithium CR2) paying attention to follow polarity indicated on the battery housing.
24