5 Operating the Receiver
Check the transmitter and receiver are working properly each time before the equipment is
put into operation.
Switching the receiver on/off and setting the volume
Turn the volume control towards ON". The Power LED lights up green. The receiver is now ready to
operate.
Set the required volume using the volume control.
The Power LED turns orange when the battery charge becomes too low.
Selecting a channel
Press the channel selection button to select the required channel A, B, C, or D. The channel cur-
rently selected is indicated by the corresponding LED.
The transmitter and receiver must be set to the same channel.
Scanning channels
Press the channel selection button, several times if necessary, to select SCAN. The SCAN LED
lights up, another LED indicates the channel currently active. The current channel switches to the next
one every 5 seconds. In this way, you can monitor several transmitters, set to different channels, on
one receiver.
Save−energy mode
Set the LCD switch to OFF". Only audio signals are then transmitted. It is recommended to switch off
the LCD when operating with battery power.
Regulating the brightness
Press the Brightness + or − button to adjust the brightness of the LCD to your specific needs.
Operating on a television set
The audio and video signals can be transmitted to a television or video recorder.
Plug the black jack plug on the audio/video cable in the AV OUTPUT socket and the yellow, white and
red phono plugs in the correspondingly coloured sockets in the input unit. For further information, refer
to the operating manual provided with the respective device.
Operating the Receiver
45