Fermax DUOX Manuel D'installation page 31

DUO DUO DUOX X X X X
DUO DUO
DUO DUOX X X X X DUO
DUO DUO
Function configuration.
First step: Configure the command and panel.
1. Press the PRG button, the C led should light up.
2. a) If you want the relay to activate with a call to residence command from all panels
press theMin/All button and the
b) If you want the relay to activate with a call to residence command from the panel that
configured it, press the Sec/Single button, and the C led should flash slowly.
3. In the panel to make a call to a residence. The relay leds should remain off.
Second step: Configuration of the command's destination (residence terminals).
The call to residence command, relative to the residence terminals receiving them can
be configured as:
a) All installed terminals (ALL).
b) Terminals from a list (maximum 100 terminals).
c) Terminals included within a defined range (consecutive).
a) Configuration: All installed terminals (ALL).
1. Press the PRG button twice, the D led should light up.
2. Press the Min/All button. The relay leds should remain off.
b) Configuration: Terminals in a list (maximum 100 terminals).
1. Press the PRG button twice, the D led should light up.
2. Press the Sec/Single button. The D led should flash quickly.
3. From a street panel, make a call to the telephone address we want to assign this
function. The Relay On led should light up if the telephone address is not on the list. The
telephone has been added to the list.
If you want to add more telephones, repeat this step.
To finish, press the PRG button.
Notice:
- When the list is complete (100 terminals), the Relay On led flashes quickly.
Steps to DELETE the complete list
1. Press the PRG button twice, the D led should light up.
2. Simultaneously press the Sec/Single and Min/All buttons. All leds should be off. The list
has been deleted.
c) Configuration: Terminals included within a defined range (consecutive).
1. Press the PRG button twice, the D led should light up.
2. Press the Sec/Single button. The D led should flash quickly.
3. Press the Min/All button. The D led should flash slowly.
4. From a street panel, make a call to the first address in the range . Leds C and D should
blink slowly.
C led should flash quickly.
Page 15