Fermax DUOX Manuel D'installation page 28

Relé
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

DUO
DUO
DUOX X X X X
DUO
DUO
DUO
DUO
DUOX X X X X
DUO
DUO
Function configuration.
First step: Configure the command and panel.
1. Make a call from a telephone in the installation and answer.
2.
Press the PRG button, the C led should light up.
3.
a) If you want the relay to activate with the Lock/release command for all panels press
the Min/All button and the
b) If you want the relay to activate with the Lock/release command for the panel that
made the call, press the Sec/Single button, and the C led should flash slowly.
4.
Press the Lock-release button on the previously used phone, the C led should turn off.
Second step: Configuration of the command´s origin (residence terminals).
The lock-release command, relative to the residence terminals sending them can be
configured as:
a) All installed terminals (ALL).
b) Terminals from a list (maximum 100 terminals).
c) Terminals included within a defined range (consecutive).
a) Configuration: All installed terminals (ALL).
1. Press the PRG button twice, the D led should light up.
2. Press the Min/All button. The relay leds should remain off.
b) Configuration: Terminals from a list (maximum 100 terminals).
1. Press the PRG button twice, the D led should light up.
2. Press the Sec/Single button. The D led should flash quickly.
3. From a street panel, make a call to the telephone address we want to assign this
function. The Relay On led should light up if the telephone address is not on the list. The
telephone has been added to the list.
If you want to add more telephones, repeat this step.
To finish press the PRG button.
Notice:
- When the list is complete (100 terminals), the Relay On led flashes quickly.
Steps to DELETE the complete list
1. Press the PRG button twice, the D led should light up.
2.
Simultaneously press the Sec/Single and Min/All buttons. All leds should be off. The list
has been deleted.
c) Configuration: Terminals included within a defined range (consecutive).
1. Press the PRG button twice, the D led should light up.
2. Press the Sec/Single button. The D led should flash quickly.
3. Press the Min/All button. The D led should flash slowly.
4. From a street panel, make a call to the first address in the range . Leds C and D should
blink slowly.
Page 12
C
led should flash quickly.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

F3257

Table des Matières