Configurations -Functions Configurations; Resetting Parameters - Fermax DUOX Manuel D'installation

DUO DUO DUOX X X X X
DUO DUO
DUO DUO DUOX X X X X
DUO DUO
2. CONFIGURATIONS - FUNCTIONS
CONFIGURATIONS

2.1 RESETTING PARAMETERS

Function description.
It performs a reset of the parameters to the default values:
- Configured command: None
-Relay address: 000
- Relay block: 00
- Bi-stable mode: Deactivated
- Panels: Not configured
- Terminals: Not configured.
- Start of the Range: Not configured.
- End of the Range: Not configured.
- List of terminals: Empty.
- Activation time: 3 seconds.
Function configuration.
1. Press the PRG button 4 times so that the C, D and T leds remain blinking rapidly.
2. Press the Min/All and Sec/Single buttons simultaneously, the LEDS remain fixed for 4
seconds so that when they are off, the relay´s configuration is reset to the default
parameters.
Notice:
- If the duox relay has been previously configured, and if you are unsure about the previous
configuration, we recommend performing a parameter rest to not interfere with the prior
configurations.
2.2 CONFIGURING ACTIVATION TIME VIA THE INTEGRATED BUTTONS (Sec/Single - Min/All)
Function description.
Configuration of activation times.
* Timed: This allows you to configure the activation time between 1 and 120 seconds
in the seconds range and between 1 and 120 minutes in the minute rage.
* Bi-stable: by activating the SET terminal the relay remains permanently activated
until deactivated by the RESET terminal.
Timed Function configuration.
1. Press the PRG button 3 times. The T led must remain lit.
2. a) If you want to configure the time in seconds press the SEC/SINGLE button, with each
press it increases the time 1 seconds and the T led flashes. If you have reached the
maximum configurable time (120 seconds), the T led flashes rapidly.
b) If you want to configure the time in minutes press the MIN/ALL button, with each press
it increases the time 1 minute and the T led flashes. If you have reached the maximum
configurable time (120 minutes), the T led flashes rapidly.
3. Once the desired configured time is configured, press PRG. All leds must be off.
Page 7