Functions; Functions Depending On Operating Mode; Tx Operating Mode; Lock-Release Function Upon Receiving A Call - Fermax DUOX Manuel D'installation

DUO DUO DUOX X X X X
DUO DUO
DUO DUO DUOX X X X X
DUO DUO
Notice:
- You can not configure the times in both ranges (minutes and seconds). If the configuration
starts within the range (minutes or seconds), continue within the same range and the
buttons pressed on the other range will not be considered.
Bi-stable function configuration.
1. Press the PRG button 3 times. The T led must remain lit.
1. Simultaneously press the buttons Sec/Single and Min/All, the leds should turn off.

FUNCTIONS

2.3 FUNCTIONS DEPENDING ON OPERATING MODE

2.3.1 TX Operating Mode

-The mode where the relay sends commands to other devices depending on the
configured command (in this mode, the relay does not activate the output).
- To access this mode configure the bridge to TX mode.
FUNCTIONS:
- Lock-release function after receiving a call.
- Lock-release function to a configured panel.

2.3.1.1 LOCK-RELEASE FUNCTION UPON RECEIVING A CALL

Function description.
You can associate the duox relay to a house so that upon calling a home you have
30 seconds, via activation of the Set terminal (button connected between the SET terminals
and -) for the Lock-release command to be sent to the panel that last made the call. This
way the user does not have to go to the house´s terminal to press the lock-release button.
Function configuration.
1. Make a call from a telephone in the installation and answer.
2. Press thePRG button, the C led should light up.
3. Press the Min/All button, the C led should blink quickly.
4. Press the Lock-release button on the previously called phone, the C led should turn off.
This way, the command is configured on the relay being serviced, now you must configure
the terminal to include the function on.
5. Press the PRG button twice, the D led should light up.
6. Press the Sec/Single button, the D LED should blink quickly.
7. Make a call to the terminal you want to have the function. Upon making the call the Relay
On led turns on for about 1.5 seconds.
8. Press the PRG button, all the leds must remain off. The function has been configured so
that when a call is made to the configured phone, you have 30 seconds to press the
Lock-release button (SET and -), and carry out the lock-release function over the panel
you called.
Page 8