Installing The Speaker; Attaching The Grille; Painting The Grille - Bose Virtually Invisible 791 II Série Notice D'utilisation

Installing the Speakers

Installing the speaker

1. Holding the outside edges, insert the speaker into
the hole.
Note: Do not press on the two small drivers on the face of
the speaker. This may damage the speaker.
Virtually Invisible 591 speaker
®
CAUTION: Certain forms of insulation (such as horse
hair plaster, newspaper, cellulose, or blown-in
materials) may pose a risk of ignition. Be sure
to keep all insulation away from the speakers.
2. Tighten all the clamp screws with a Phillips
head screwdriver.
Note: If using a power drill, choose the lowest
torque setting.
Virtually Invisible 591 speaker
®
6 - English

Attaching the grille

The grille magnetically attaches to the rim of the speaker.
Place the grille on speaker.
Virtually Invisible 591 speaker
®

Painting the grille

You can paint the speaker grilles before you attach them to the
speaker. Bose is not responsible for the quality of adhesion or
®
finish of non-factory-applied paints.
• Latex or oil-based architectural paint requires thinning for
use with a siphon-feed spray gun. Refer to the owner's guide
provided with your spray gun for guidelines.
• Be careful when using a sharp implement in the grille
perforations to remove a paint clog, which can damage
the grille.