Waeco MagicSpeed MS800 Instructions De Montage Et De Service page 70

_MS-800.book Seite 70 Donnerstag, 1. Juni 2006 8:22 08
Diagnosis mode
9.2 Diagnosis mode B
Diagnosis mode B tests the function of the interface module.
➤ Apply the handbrake.
➤ Shift the gearbox to neutral, or to neutral or park if it is automatic.
➤ Press and hold down the SET button.
➤ Start the engine.
➤ When the engine is running, let go of the SET button.
➤ Now switch on the speed controller using the ON/OFF button on the
control element.
✓ The LED in the control element lights up.
Caution
Do not let the engine overrun.
➤ To increase the engine speed press and hold down the SET button.
✓ The engine speed slowly increases.
➤ To lower the engine speed press and hold down the RES button.
✓ The engine speed slowly drops.
➤ To drop the engine speed to the idle speed again,
– Apply the brake or clutch, or
– Press the ON/OFF button on the control element.
➤ To quit diagnosis mode, switch off the ignition.
70
MagicSpeed MS800