Installation - BORETTI PICCOLINO Notice D'emploi

Installation

Use only the hose and hose connector
provided!
• If a replacement is necessary, please
contact either our Customer
Step 1
Put one washer through each screw. Then, put one washer with doubled sided tape each on top of
the screw hole in the front.
Step 2
Remove the flame tamer above the grid as per the picture shown below.
26
Service Department or your local dealer.
• The use of unauthorised parts can create
unsafe conditions and environment.
Step 3
Line up screws and screw holes of the leg assembly with holes on the fire box, and then drop the grill on
the leg assembly. As per picture below, install the legs in the flat position with hinge folded up. Tighten
the wing nuts (A) into the holes in the front and back.
Step 4
Place the flame tamer, drip tray and grill as per picture below.
NL
FR
EN
EENN
27