Bosch EXTEGRA IP 9000 FX Manuel D'installation page 25

EXTEGRA IP 9000 FX
P102 = Alarm and Relay
PIN 1
PIN 2
PIN 3
PIN 4
PIN 5
PIN 6
PIN 7
PIN 8
PIN 9
P101 = Audio
PIN 1
PIN 2
PIN 3
PIN 4
PIN 5
PIN 6
PIN 7
5. Feed the Ethernet cable with an RJ45 connector through one of the four 3/4-in. conduit
entries. Connect the RJ45 connector of the Ethernet cable to the RJ45 terminal inside the unit
(item 1 in the following figure).
Figure 6.4: RJ45 connector
6. If desired, install the OFC Kit. Follow the installation instructions provided in the kit.
If the optional OFC kit has been installed, connect a terminated fiber optic cable to the female
ST connector.
7. Clean and grease the O-ring and threads before replacing the front end cap. Refer to
Installation Overview, page 17.
8. Replace the front end cap.
9. Tighten the front end cap using the multi-use tool. Ensure that the O-ring is properly
seated. After tightening, ensure that there is no gap between the cap and the body of the
housing.
10. Tighten the set screws on the front end cap using the supplied hex key.
Bosch Security Systems
Alarm_IN1 (Alarm Input 1)
Alarm_IN2 (Alarm Input 2)
Alarm_IN3 (Alarm Input 3)
Alarm_OUT1 (Alarm Output 1)
Alarm_OUT2 (Alarm Output2)
Alarm_GND (Alarm Ground)
Relay_NO (Relay Normally Open)
Relay_COM (Relay Common)
Relay_NC (Relay Normally Closed)
Audio IN+
Audio IN-
Audio OUT+
Audio OUT-
Future use
Future use
Future use
Installation Manual / Guide d'installation
Connections | en
25
2016.02 | 1.2 | F.01U.319.357