Bosch EXTEGRA IP 9000 FX Manuel D'installation page 18

en | Installation Overview
18
Ambient operating range
when powered by 24 VAC
Ambient operating range when powered by
HPoE
–
–
–
–
Note: For instructions to configure the camera, refer to the Software Manual. Go to http://
www.boschsecurity.com, navigate to the product page for your camera, and then locate the
document in the Documents tab.
Note: This product is serialized to ensure traceability.
Technical information for thread adapter
–
–
–
–
–
2016.02 | 1.2 | F.01U.319.357
If starting up the unit below -40 °C, there may be a delay (up to 30 minutes) between
when power is applied to the camera and when video output is available.
The joint between the junction box and housing is secured by a thread locker for
permanent securement. This joint shall not be removed because there may be damage to
the flame path threads.
The device was subjected to the resistance to impact test at 2 J. It shall be installed
where it will not be subjected to impact.
For ambient temperatures below –10 °C, use field wiring suitable for the minimum
ambient temperature.
Manufacturer – Hazardous Location Solutions, LLC
Aluminum model number supplied with Aluminum housing EXTEGRA Camera: R1.3/4.20.N
Stainless Steel model number supplied with Stainless Steel housing EXTEGRA Camera:
R1.3/4.20.S
Thread adapters are certified under certificates: SIRA 07ATEX1175X and IECEx SIR
07.0046X
Flameproof joint information between the adapter and EXTEGRA Camera housing when
installed: minimum 5 full threads engaged
Installation Manual / Guide d'installation
-50 °C to 60 °C -50 °C to 55 °C
(-58 °F to 140 °F) (-58 °F to 131 °F)
-40 °C to 60 °C -40 °C to 55 °C
(-40 °F to 140 °F) (-40 °F to 131 °F)
EXTEGRA IP 9000 FX
Bosch Security Systems