Bosch EXTEGRA IP 9000 FX Manuel D'installation page 21

EXTEGRA IP 9000 FX
Figure 5.4: Card slot with SD card installed
7. Slide the assembly into the housing.
8. Tighten the 2 securing bolts to secure the assembly. Note: Do not overtighten the screws. If
you overtighten, you will deform the mounting bracket.
Figure 5.5: Tighten the 2 bolts
9. Clean and grease the O-ring and threads before replacing the front end cap. Refer to
Installation Overview, page 17.
10. Replace the front end cap.
11. Tighten the front end cap using the multi-use tool. Ensure that the O-ring is properly
seated. After tightening, ensure that there is no gap between the cap and the body of the
housing.
12. Tighten the set screws on the front end cap using the supplied hex key.
Set screws must not protrude from the threaded hole after tightening.
See also
–
Bosch Security Systems
Installation Overview, page 17
Installation Manual / Guide d'installation
Install the Optional Media Storage Card | en
2016.02 | 1.2 | F.01U.319.357
21