Bosch EXTEGRA IP 9000 FX Manuel D'installation page 24

en | Connections
24
2
NEUTRAL
1
LINE
Figure 6.2: User Connections on User Interface Board for 24 VAC (P103), Alarm and Relay (P102), and Audio (P101)
To make connections, follow these steps.
1. Loosen the set screws on the rear end cap using the supplied hex key. Loosen the rear end
cap using the multi-use tool. To prevent damage to the o-ring, for every half turn
counterclockwise turn back one quarter-turn clockwise.
Note: To prevent damage to the cap threads, take care not to drop the end caps.
Figure 6.3: Removal of end cap with multi-use tool
2. Unscrew the rear end cap by hand. Set the cap aside.
3. Feed the 24 VAC cable through one of the four 3/4-in. conduit entries. Feed the following
cables as necessary through any one of the four 3/4-in. conduit entries: the fiber optic cable,
the alarm and relay cables, and the audio cable.
4. Make the connections to the terminal connectors.
–
–
–
P103 = 24VAC IN
PIN 1
PIN 2
2016.02 | 1.2 | F.01U.319.357
P103
9
S100
7
Remove the terminal connectors from the User Interface Board (if necessary).
Make the connections, using the following three tables of pin outs as reference.
Insert the terminal connectors on the User Interface Board.
LINE24V
NEUTRAL24
Installation Manual / Guide d'installation
P102
1
P101
1
EXTEGRA IP 9000 FX
Bosch Security Systems