Safety Information; Layout And Items Supplied - EINHELL BG-PC 2625 T Mode D'emploi

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Safety information

For the relevant safety information please refer to
the booklet included in delivery.
Danger!
Read all the safety information and instruc-
tions. Any errors made in following the safety
information and the instructions set out below
may result in an electric shock, fi re and/or serious
injury. Keep all safety information and instruc-
tions in a safe place for future use.
Explanation of the symbols on the equipment
(Fig. 30):
1. Warning!
2. Wear protective headgear, goggles and ear
muff s.
3. Wear safety gloves.
4. Watch out for falling and catapulting parts.
5. Read the directions for use before operating
the equipment.
6. Wear sturdy, non-slip footwear.
7. Protect the equipment from rain and damp.
8. Always switch off the equipment and pull out
the spark boot plug before carrying out any
maintenance work.
9. Electric shock can cause fatal injury. Keep a
distance of at least 10 m from power cables.
10. Direction of the chain movement and teeth.
11. Caution: Hot equipment parts. Keep your dis-
tance.
Anl_BG_BC_2625_T_SPK7.indb 23 Anl_BG_BC_2625_T_SPK7.indb 23
GB

2. Layout and items supplied

2.1 Layout
1. Cutter bar
2. Saw chain
3a. Oil tank / cap
3b. Gear unit
4. Drive rod mechanism
5. Connecting piece
6. Additional handle
7. Eyelet
8. Handle
9. On/Off switch
10. Throttle lever lock
11. Throttle lock
12. Throttle lever
13. Spark plug boot
14. Starter cable
15. Petrol tank / cap
16. Air fi lter housing cover
17. Choke lever
18. Clip
19. Screw (4x)
20. Nut (4x)
21. Open-ended wrench size 8/10
22. Allen key size 4mm
23. Allen key size 5mm
24. Cutter guard
25. Carrying strap
26. Oil/petrol mixing bottle
27. Multifunction tool
28. Lubrication nipple
29. Fuel pump „primer"
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are present.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, keep the packaging until the end
of the guarantee period.
- 23 -
29.10.14 09:33 29.10.14 09:33