Troubleshooting; Malfunction Causes And Remedies - Powerfix Profi PLPRS A2 Mode D'emploi

Smoothing (Fig . F)
♦ Allow the hard wax to cool for a few seconds
(about 10 seconds) .
♦ After cooling, smooth any protrusion with the
planing grooves of the scraper
light pressure to smooth the protrusion .
Fine matching (Fig . G)
♦ For fine matching, now imitate the grain struc-
ture with a darker colour tone .
♦ Subsequently, again smooth any protrusion
with the planing grooves of the scraper
Degreasing (Fig . H)
♦ To finish, remove the last hard wax residues
with the sanding sponge
gloss level of the surface will also be simulta-
neously matched . Job done!
Cleaning the planer grooves (Fig . I)
♦ Place the cleaning scraper
grooves of the scraper
residues from the plane grooves .

Troubleshooting

In this chapter you will receive important informa-
tion for malfunction localisation and malfunction
remedies .

Malfunction causes and remedies

The following table will help with localising and
remedying minor malfunctions:
Defect
The wax melter
tip does not
get hot .
NOTICE
► If you cannot solve the problem with the
aforementioned solutions, please contact the
Service Hotline (see chapter Service) .
PLPRS A2
and scrape the wax
Possible
cause
The batteries
have been
inserted incor-
rectly .
The batteries
are discharged .
. Use only
. Thereby the
on the plane
Solution
Insert the bat-
teries as per
the depiction
in the battery
compartment .
Insert two
new batteries .
GB │ IE │ 23
.
■