Handling And Operation; Switching The Appliance On/Off; Application Example - Powerfix Profi PLPRS A2 Mode D'emploi

Handling and operation

In this chapter you will receive important infor-
mation for the handling and operation of the
appliance .

Switching the appliance on/off

♦ To switch the appliance on, place the On/
Off switch
♦ Press and hold the activation button
heat up the wax melter tip
will remain lit as long as you hold down the
activation button
♦ To switch the appliance off, place the On/
Off switch

Application example

Preparation (Fig . A)
♦ Clean the damaged area with the spatula
and remove all loose parts . Press the edges
of the damaged area round .
Colour selection (Fig . B)
♦ Select the matching colour tone .
Ensure that several colour tones, from light to
dark, are always used . With real wood, it is
recommended to additionally work with trans-
parent (K), so as to achieve a sense of depth .
Melting and filling (Figs . C + D)
♦ Place the On/Off switch
"ON" to switch the appliance on .
♦ Press and hold the activation button
heat up the wax melter tip
reaches operating temperature after about
30 seconds .
♦ Now melt small portions of the hard wax and
place them into the damaged area, until it is
slightly overfilled . Start with the light colour
tones and progress step by step to the dark
colour tones .
NOTICE
► At pressure points it is often sufficient if you
use only the transparent hard wax (K) .
Filling (Fig . E)
♦ For vertical surfaces it is recommended to mix
the colour tone beforehand, collect it on the
spatula
When working on curved areas the scraper
with curvature
wax into the damaged area .
■ 22 │ GB │ IE
at the position "ON" .
.
at the position "OFF" .
and then fill the damaged area .
should be used to fill hard
to
. The red LED
at the position
to
. The appliance
PLPRS A2