Sony Ericsson HBH-30 Manuel page 10

To make a call using voice dialling
1. Make sure the phone and the headset are on and within
range of each other. Press
2. After the beep, voice dial as you normally would.
If using the Bluetooth phone adapter: Say the voice
command after the phone beep (not after the headset
beep). To know when the phone beeps in relation to
the headset beep, make a test call using voice dialling.
3. End the call by pressing
You can also make a call using the phone's keypad
or phone book (if, for example, your phone does not
support voice dialling).
Answering calls
To answer a call using
1. When the headset rings, press
Note: If the phone rings first, wait until the headset
rings, then press
2. End the call by pressing
To answer a second call
• You have to use the phone keypad to answer and
handle a second call, but you can still use the headset
for talking and listening. You cannot use the headset
10 Using the headset
.
.
.
.
.
buttons during a second call. Refer to the phone's user
documentation on how to handle more than one call
simultaneously.
To reject a call
• When the headset rings, press and hold
hear a long beep.
To turn off the microphone
• During a call, press and release both
to turn off the microphone. A repeated beep is heard
while the microphone is turned off.
• Press and hold both
the conversation.
Using voice commands
Voice commands are especially useful when you are
using the headset. For information on voice commands,
refer to the phone's user documentation.
Adjusting the speaker volume
You can adjust the headset speaker volume during a call.
To adjust the speaker volume
• To increase the volume, press
• To decrease the volume, press
until you
and
and again to resume
.
.