Sony Ericsson HBH-30 Manuel page 11

Adjusting the ring volume
You can adjust the headset ring volume when you are
not engaged in a call.
To adjust the ring volume
• To increase the ring volume, press
• To decrease the ring volume, press
Note: The headset uses increasing volume. For safety
reasons, it starts with a low volume level before the
maximum set level is reached.
Transferring sound from phone to headset
If you make a call without using the headset, you can
transfer the sound to the headset if the headset is on,
paired with the phone and within range.
To transfer the sound to the headset
• During a call, press and hold
to the headset. The headset beeps until the sound has
been transferred.
If the headset is turned on after a call has been initiated,
you can transfer the sound to the headset by pressing
and holding .
.
.
1. Make sure the headset is turned on. Then press and
2. The battery status is indicated by one of these three levels:
to transfer the sound
Note: To transfer the sound from the headset to the
phone refer to the phone's user documentation.
Lost connection to headset
If the connection to the headset is lost during an
ongoing call you must confirm the sound transfer to
the phone by pressing the
otherwise the call is disconnected after 30 seconds.
Headset battery status
The headset comes with a built-in battery.
To check the battery status
release both and
• High – three green flashes
• Medium – two green flashes
• Low – one green flash
key on the phone,
YES
.
Using the headset 11