Clothing; Use - Texas A/S Hobby 300 Manuel De L'utilisateur

3. Add grease until it comes out of the filler hole when the gearbox is in horizontal
position.
4. Operate the clutch lever and pull the starter cord 3 times to distribute the grease
around the gear.
5. Then add more grease until the gear is full.
6. Fit and tighten the screw.
7. Fit the spark plug cover on the engine.
Figure 6
Check grease level and add grease to the gear for every 5 operating hours

Clothing

When working with the tiller, close-fitting work clothes, sturdy
work gloves, hearing protection and boots with non-skid soles
and steel toe caps are compulsory.

Use

Remove all foreign bodies form the area before use. Stone, glass, branches, etc. can
damage the tiller. Check that all bolts on the tiller are tightened.
Warning: Stay out of dashed zone, while starting the engine! Always start the
Starting:
Set the throttle handle to choker/full throttle.
Follow the engine instructions for starting.
Stopping:
Set the throttle handle to minimum throttle.
Follow the engine instructions for stopping.
The tiller is designed for cultivating vegetable gardens and flowerbeds. The machine can
also be equipped with various accessories for a variety of tasks.
Read the instructions carefully and make sure you are familiar with how to start and stop
the engine in particular.
Fig 4.1: When the clutch cable on the right side of the handle is pressed down, the blades
are activated. It is important that the handle is pressed fully down to the handlebar. This
will ensure optimum tightening of the belt, which transfers the power from the engine to the
transmission.
Fig 4.2: To use the black handle, the control stick must first be activated. By tilting the
control stick to the right side and activating the black handle, the tiller will move forward.
The ground should generally be tilled 2-3 times in different directions. Figure 9
Do not cultivate very wet soil, as clods will be formed, and these are difficult to break up
again. Very dry soil may need to be cultivated twice.
Grease is not included!
engine from dotted safety zone See Fig 10
9