Assembly Of Model 572; Clothing; Use - Texas A/S 530 Manuel De L'utilisateur

Assembly of model 572

1. Figure 1A shows the contents of the package:
a. Tiller
b. Upper steer with cables
c. Side guards
d. Blades
e. User manual and bolts
2. Mount upper steer using the accompanying bolts and handwheel. Pay attention to
the bolt. It must pass through the spring
Figures 2, 3.
3. Mount the side guards using the accompanying bolts and nuts.
Figure 4.
4. Mount the blades using the cotter bolts and pins.
It is important that the edge of the blade turns forward, as shown in figure 6, a.
Figures 5, 6.
WARNING: Follow the guide in the user manual to fill the engine with oil and fuel.

Clothing

When working with the tiller, wear close-fitting work clothes,
sturdy work gloves, hearing protection and boots with non-skid ¨
soles, and steel nose is compulsory.

Use

Clean the area of all foreign items before use. Stone, glass, branches, etc. can damage the
tiller. Check that all bolts on the tiller are tightened.
Warning: Stay out of dashed zone, while starting the engine! Always start the engine
Start:
Place the throttle handle on choker/full throttle.
Follow the guide in the user manual to start.
Stop:
Place the throttle handle on minimum throttle.
Follow the guide in the user manual to stop.
Fig 13 + 13A: When the black gear lever on the right of the handle is hold, the rotor blades
begin to turn. To ensure optimum belt tension, is it important to hold the lever all the way
down towards the handle. The belt transmits power from the engine to the transmission.
The Lilli 532 and 572 is fitted with a reverse gear. To operate, press the red handle.
from dotted safety zone See fig 10
11