Torque - Quickie Nitrum Notice D'utilisation

13.0 Torque

20 Nm
7Nm
7Nm
10Nm
20 Nm
Torque.
NOTE: Wherever torque settings are specified, it is strongly recommended that a torque meter (not included), is used to verify correct
torque specification is achieved.
If no other information is given, the generic torque for M6 screws is 7 Nm.
CAUTION: Some of the screws that are used during manufacture are fitted with threadlock, (blue dot on the thread) and can be undone
and re-tightened up to three times before they must be replaced with new screws and threadlock. Alternatively, you can put Loctite™
243 threadlock on the screws and re-fit them.
57
Nitrum / Nitrum Hybrid Rev.D