Torque - Quickie Krypton R Notice D'utilisation

12.0 Torque

5 Nm
7 Nm
5 Nm
5 Nm
5 Nm
5 Nm
7 Nm
7 Nm
To avoid damage to the Carbon tube, ensure that the spacer is in place.
A
TORQUE.
NOTE: Wherever torque settings are specified, it is strongly recommended that a torque meter (not included), is used to verify correct
torque specification is achieved.
If no other information is given, the generic torque for M6 screws is 7 Nm.
CAUTION: Some of the screws that are used in manufacture have a thread lock (blue dot on the threads) and can only be loosened
and tightened again a maximum of three times, then they must be replaced by new screws You could also apply Loctite™ 243 screw
lock to the screws and then refit them.
Krypton R Rev.1.0
5 Nm
25 Nm
5 Nm
5 Nm
5 Nm
7 Nm
A
5 Nm
3 Nm
5 Nm
3 Nm
5 Nm
5 Nm
25