Overview; Connection Of Hose; Connection Of Pipe; Electrical Connection - Ecolab OGM PLUS Manuel D'utilisation

Installation
5.5.1

Overview

1
2
3
4
5
6
Fig. 4: Overview
1 Hose
1a Pipe
2 Union nut
3 Clamping element
5.5.2

Connection of hose

Note data on the in-pack notelet with the hose connecting elements!
Cut the hose (Fig. 4, pos. 1) at right angles.
n
n Slip the union nut (pos. 2) and clamping element (Pos. 3) over the hose.
n Slip the hose onto the cone (pos. 4) up to the stop collar.
n Position the O-ring seal (pos. 5) into the groove provided on the connecting adapter
(pos. 6).
n Connect the hose and cone (pos. 4) and tighten the union nut (pos. 2).
5.5.3

Connection of pipe

n Cut the pipe (Fig. 4, pos. 1a) at right angles.
n Slip the union nut (pos. 2) over the pipe.
Weld / adhesive bond the insert (pos. 3a) to the pipe.
n
n Position the O-ring seal (pos. 5) in the groove provided on the connecting adapter
(pos. 6).
n Tighten the union nut (pos. 2).
5.6

Electrical connection

PLUS
The OGM
Electrical connection is accomplished by means of a four-pole M12 connector.
417102208 Rev. 8-11.2019
1a
2
3a
5
6
electronic evaluation system is moulded into the cover.
3a Insert element
4 Cone
5 O-Ring
6 Connecting adapter
28