TYLOHELO Elite Mode D'emploi page 49

Wi-Fi
With the Tylö Elite Wi-Fi control panel, you can connect the control panel to your local Wi-Fi
network (i.e. not from the Internet). You can then use an app (iOS or Android) or a program on
your computer to enter settings, control and monitor your sauna or steam room. The TylöHelo
control app is available free from the App Store and Google Play. The PC app is available from
TylöHelo's website (https://www.tylohelo.com/en/control-panel-tylo-elite).
Bear in mind that the position where the control panel is located affects how well it can com-
municate with the wireless network. Many kinds of material disturb the Wi-Fi signal. stem and
go into Network. Available networks will be displayed with a relative signal strength indicated
in % after each name. The signal strength must be at least 60% or you risk losing the connec-
tion. If the signal strength is less than 60%, a new access point or repeater must be installed
near the Elite panel. .
The system supports WPA/WPA2 personal SSID+Password. If your router uses WPA Enter-
prise (user + password), you will need to configure it to support WPA/WPA2 personal as well.
The password can contain a maximum of 20 characters.
In order to use Wi-Fi with a sauna device or Combi device, a door switch must be connected
(Tylö part no. 90908035). No door switch is required for steam rooms, but its use is strongly
recommended. When the door switch is connected to the steam room, this enables the steam
generator to switch off automatically if the door is left open for more than five minutes while
the device is operating, thus preventing unwanted damp.
In order to connect to your local network, first activate Wi-Fi and press Network. Now press
Scan which searches for available networks. In order to connect, press on the desired
network; if a password is required press Password, enter the password and then press Con-
nect. In order to connect mobile or computer applications, refer to the app instructions on the
Tylö website (www.tylo.com/elite).
Under Name you can name your system. A default name is present to begin with, and this
depends on the system you have. Press the name to change or alter it. A keyboard will appear
for editing.
Press External units to see what is connected to the control panel.
If you activate Auto connect the Elite Wi-Fi will automatically connect you to the selected
network after a power cut.
When the Elite is connected to a network, the WiFi symbol will appear on the Home screen.
However, the symbol does not show the signal strength. This can only be seen in the network
menu.
In order for iPhones, Android phones and computer applications to connect to the Elite, UDP broad-
cast for ports 54377 and 54378 must be open in the router to which they are connected. The primary
port is port 54377, but if it is busy unexpectedly, port 54378 is used instead.
The local network must be set on the 2.4 GHz band. The 5 GHz band is not supported by the system.