TYLOHELO Elite Mode D'emploi page 47

Masquer les pouces Voir aussi pour Elite:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 119
Configure: System settings.
Time
Setting the time and selecting the time format.
Date
Setting the date and date format.
There are several date formats to choose from:
YY/MM/DD – Swedish format. Also used in some parts of Asia.
DD/MM/YY – Format used in most parts of the world.
MM/DD/YY – Usual format in the USA.
Week starts
Enter the day to be used as the first day of the week. This is defined so that the calen-
dar is displayed correctly.
Erase calendar
Pressing Erase calendar will delete all calendar items and day-based programs.
Bath temperature
Define the maximum temperature that can entered under settings or in calendar pro-
grams and Favourites.
Not allowed start
This setting allows you to lock the system so it cannot start. Set the times between
which the system should be locked. The time lock applies to all days of the week.
When the time lock is active, all current programs and manually initiated sessions
are shut down. If you try to create a program that starts or finishes at a time when the
system is locked, you will see a warning notification about this.
Overheating
Circuit boards in sauna devices can overheat in certain situations. When the temperature of the circuit
board reaches the PCB limit, the sauna switches off automatically. Overheating may be due to various
causes, e.g. poor ventilation. It is possible to change the temperature when the sauna is switched off.
If the device overheats, contact a service engineer to investigate the problem. Increasing the limit as
to when the sauna is switched off risks substantially shortening the life cycle of the device. We recom-
mend that this setting only be changed by a qualified Tylö engineer.
In steam generators, the maximum temperature setting in the water tank applies. If the temperature
is exceeded, the water tank will be emptied. If the water temperature reaches this temperature, it is
probably because the water quality has deteriorated to the point where the water is foaming. In this
situation the heating element is at risk of damage.

Publicité

Table des Matières
loading

Table des Matières