TYLOHELO Elite Mode D'emploi page 45

Configure: System settings.
If multiple panels are connected, certain settings are specific to each panel. For example, you can have different language settings, different
PIN locks and displays on locked screens, temperature and humidity filtering, different times before the screen switches off and different date
and time formats. This is set individually on each panel.
If multiple systems are linked (e.g. Tylarium or multi-steam) information on these is displayed under About.
Unit
Select the unit of temperature that will be displayed.
Display
You can set the screen to switch off after a certain time. This can be set to anything
from 15 seconds to 15 minutes. There is also an option for the screen never to switch
off.
PIN
The control panel can be locked so that others cannot modify settings, temperature,
etc. You can set certain functions to be available even when the panel is locked.
Activate the code lock via the slider labelled "Activate PIN". The default code is 0000.
To change the code, press "Change PIN". You will need to enter the current code fol-
lowed by the new code, and then confirm the new code.
You can allow certain functions to be visible even when the panel is locked. Tick the
functions that should be available even when the panel is locked.
The PIN code lock will activate 1 minute after the screen was last touched, if the PIN code
lock is enabled.
If several Elite panels are connected to the same system, the PIN is panel-specific. Each panel
has a separate PIN, and the PIN does not have to be activated on all the panels.