Pressure Washer Location - Briggs & Stratton ELITE Serie Manuel De L'utilisateur

Pulvérisateur à pression
Masquer les pouces Voir aussi pour ELITE Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

HOW TO USE YOUR
PRESSURE WASHER
If you have any problems operating your pressure washer,
please call the pressure washer helpline at 1-800-743-4115.

Pressure Washer Location

Pressure Washer Clearance
WARNING
Running engine gives off carbon monoxide, an
odorless, colorless, poison gas.
Breathing carbon monoxide will cause nausea,
fainting or death.
• Operate pressure washer ONLY outdoors.
• Keep exhaust gas from entering a confined area through
windows, doors, ventilation intakes or other openings.
• DO NOT operate pressure washer inside any building or
enclosure.
The pressure washer must be at least 5 ft. (152 cm) from
structures having combustible walls and/or other
combustible materials. Leave at least 3 ft. (92 cm) all around
pressure washer including overhead, for adequate cooling,
maintenance and servicing.
Place pressure washer in a well ventilated area, which will
allow for removal of deadly exhaust gas. DO NOT place
pressure washer where exhaust gas could accumulate and
enter inside or be drawn into a potentially occupied
building. Ensure exhaust gas is kept away from any
windows, doors, ventilation intakes or other openings that
can allow exhaust gas to collect in a confined area
(Figure 7). Prevailing winds and air currents should be taken
into consideration when positioning pressure washer.
Figure 7 — Pressure Washer Clearance
2450 PSI Pressure Washer
Typical Pressure
Washer Shown
Exhaust Port
How to Start Pressure Washer
To start your pressure washer for the first time, follow
these instructions step-by-step.This starting information
also applies if you have let the pressure washer sit idle for
at least a day.
1.
Place pressure washer near an outside water source
capable of supplying water at a flow rate greater than
3.0 gallons per minute and no less than 20 PSI at
pressure washer end of garden hose.
2.
Check that high pressure hose is tightly connected to
spray gun and pump. See "Preparing Pressure Washer
for Use" for illustrations.
3.
Make sure unit is in level position.
4.
Connect garden hose to water inlet on pressure
washer pump. Turn ON water.
CAUTION
DO NOT run the pump without the water supply
connected and turned on.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
5.
Squeeze spray gun trigger until a steady stream of
water occurs.
6.
Attach nozzle extension to spray gun (Figure 8).
Tighten by hand.
Figure 8 — Connect Nozzle Extension to Spray Gun
7.
Position nozzle in low pressure mode (slide nozzle
forward) and squeeze trigger on spray gun to relieve
pressure caused by turning ON water.Water will flow
out of gun in a thin stream. Continue to hold trigger
until there is a steady stream of water and no air
remains in system. Release trigger.
8.
Engage safety latch to spray gun trigger (Figure 9).
Figure 9 — Spray Gun with Safety Latch Engaged
8
Safety Latch

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Elite 2450 psiElite 020219020219

Table des Matières