Confirmation - Alpine NVE-N872A Guide D'installation

a When mounting with floor base
brackets
1
Mount the brackets 1.
Mount the brackets 1 at both sides of the unit
with screws with double washer (M4×8) 3.
1
3
2
Determine mounting position of the floor
bases 2 for placement under the carpet.
8

5. Confirmation

1
Turn on the engine key. Make sure the unit is
operating correctly by referring to the
Owner's Manual.
ON
2
Make sure all factory components such as the
brake lamps, etc. work correctly.
Depending on the
locations of the mounting
screw holes, the
mounting brackets (for
the left and right) can be
used on either side.
1
3
6
2
3
Cut the carpet in "x" shape with a cutter and
insert the floor bases 2 from under side of
the carpet.
4
Mount the unit on the carpet with spring
washers (M6) 6 and wing nuts (M6) 8.
Continued to step 5 "Securing leads, etc."
5
Securing leads, etc.
Make sure leads are not pinched by moving parts
such as the seat rail, etc. Also check for dam-
aged from sharp edges or protrusion.
6
Connect the battery (−) terminal.
a Remote control holder mounting method
• If the remote control is in direct sunlight, remove it
from the holder and keep it in the glove box.
• When the holder cannot be mounted securely with
double-sided adhesive tape !, mount it by using
screws ".
Reinforcement screws "
Remote
control
holder
Protective
Paper
Console box, etc.
* Double-sided adhesive tape. (Before attaching
the tape, make sure the mounting location is free
from dust or dirt.)
2
8
6
Remote control
!*
13