Combining Manual And Auto Operation; Cleaning; Flushing The Cutting Chamber - Struers Discotom-6 Mode D'emploi

Combining Manual and
Auto Operation

Cleaning

Flushing the Cutting Chamber

Cooling Valve
The cooling valve for cooling/cleaning
is located on the left hand side of
Discotom-6.
Turn the knob
clockwise to
vertical position
to cool the cut-
off wheel.
Turn the knob
counter-
clockwise to
vertical position
to flush the
cutting
chamber.
Discotom-6
Instruction Manual
Manual and Automatic cutting mode may be used in combination.
You may start in manual mode and cut into the workpiece. If you lock
this position you can continue in automatic mode, and the workpiece
will move towards the cut-off wheel.
To ensure a longer lifetime for your Discotom-6, Struers strongly
recommends that you clean the cutting chamber with the flushing
gun every day.


Press STOP to stop the cut-off wheel and cooling water.

Open the protection guard and release the workpiece from the
quick-clamping devices.

Take the flushing gun from the left hand side of the cutting
machine and point it towards the bottom of the cutting chamber.

Turn the cooling valve to cleaning position (see sketch at left)

Clean the cutting chamber thoroughly.
Do not clean the protection guard with the flushing gun;

Turn the cooling valve to cooling position.

Leave the protection guard open to let the cutting chamber dry
completely.
Leave the protection guard open to let the cutting chamber dry completely.
Note:
use a damp cloth instead.
AVOID RUST!
15